Chevron Digital Timer Ew-32 User Manual !new! -

Built-in rechargeable backup battery (retains programs during power outages) Minimum Switching Time: 1 Minute Operating Temperature: 14°F to 104°F (-10°C to 40°C) Package Contents 1 x Chevron EW-32 Digital Plug-In Timer 1 x Instruction Manual 2. Button Layout and Screen Icons

Used to set current time, or return to time display mode. PROG/TIMER: Sets the daily/weekly programs. WEEK/HOUR/MIN/SEC: Used to adjust time and scheduling. ON/AUTO/OFF: Selects the operating mode. 3. Getting Started: Initial Setup

: Before the first use or if the screen is blank, plug the timer into a wall outlet for at least to charge the internal memory backup battery. : Use a pin or paperclip to press the button to clear any old settings and start fresh. Setting the Current Time Press and hold the button for 3 seconds until the display begins to flash. buttons to adjust the to confirm each selection and finish the clock setup. Programming On/Off Cycles The EW-32 typically supports up to 10 unique on/off programs chevron digital timer ew-32 user manual

The Chevron EW-32 is a with a grounded outlet (3-prong). Unlike older mechanical timers that use pins and dials, the EW-32 uses a battery-backed digital interface, allowing it to keep accurate time even during a power outage.

The outlet remains continuously powered. Saved programs are ignored. WEEK/HOUR/MIN/SEC: Used to adjust time and scheduling

The LCD screen will flash, clear, and reset to factory defaults (12:00 AM, Monday). 4. Setting the Current Time and Day

Press and hold the for 3 seconds to toggle the display between standard 12-hour AM/PM time and 24-hour military time. Activating Daylight Saving Time (DST) To quickly advance the clock by one hour for summertime: Getting Started: Initial Setup : Before the first

Press the "Time" (or Clock) button for 3 seconds to switch between standard and military time formats. Setting Your On/Off Schedules

While holding , press the HOUR button to cycle through hours. Note the AM/PM indicator on the screen to ensure correct noon/midnight alignment.

Use a thin object like a paper clip to press the "R" (Reset) pinhole button. This clears any existing data and readies the system for fresh programming. Programming the Current Time and Day