Turn on, turn off, dim up, dim down, or trigger sequences. 🚀 Step-by-Step Programming Guide

To maximize project success and speed up commissioning using HDL Buspro Setup Tool 2, adhere to these operational guidelines:

To ensure stability during programming, your engineering PC must meet specific hardware and software criteria. Hardware & Software Requirements

: To modify a device's address, you must typically enter "Setup Mode" by holding the physical programming button on the device for 3 seconds. Programming Procedures

When you click a device, its parameters appear here. For a switch, you define button behavior. For a sensor, you set the lux threshold.

Connect your computer to the same network as the HDL TCP/IP interface.

Assign targets: Link a button to a specific relay channel or a broader "Scene".

Configuring HDL thermostats requires matching the module targets to your dedicated HVAC controllers. Setup Tool 2 allows you to calibrate internal temperature sensors, define deadbands for heating and cooling cycles, and configure fan speeds (Low/Medium/High) to prevent equipment short-cycling. Logic Block Programming

: It supports backing up and restoring device data, as well as performing online or manual firmware upgrades.

Warning: Projects saved in V2 are not backwards compatible with V1. Always export a plain-text logic report if you need to downgrade.