If the chiller is exposed to environments below 0°C, the water inside can freeze and crack the internal evaporator.
Clear escalation paths and required evidence significantly shorten repair cycles.
Cooling failure. Clean dust filters, check refrigerant levels, or reduce laser load. Ultra-low water temperature
The chiller maintains a fixed user-defined temperature regardless of ambient shifts. This mode is preferred in highly climate-controlled facilities. Changing Parameters (e.g., Switching to Constant Mode) To modify settings, you must unlock the controller panel: cwfl-6000 manual
The CWFL-6000 operates on 380V three-phase (standard) or 220V single-phase (variant). The manual includes a detailed wiring diagram showing:
Use a compressed air gun to blow dust off the condenser. Winter Care: If the room temperature drops below 2∘C2 raised to the composed with power C
and the machine is idle, to prevent the pipes from freezing and cracking. Common Alarms & Solutions Alarm Symptom Likely Cause Recommended Action E1 Ultra-high room temperature Improve ventilation or lower ambient temperature. E2 Ultra-high water temperature Check for refrigerant leaks or heavy dust on the condenser. Flow Alarm Low water level or blocked pipes If the chiller is exposed to environments below
Keep the unit in a well-ventilated, dry indoor environment. Avoid direct sunlight, corrosive gases, and extreme dust. Operating ambient temperature should ideally be under 40°C. Electrical Connections
: Never turn on the chiller without water in the tank.
Pin configurations for the alarm plug are detailed on the electrical schematic sticker located inside the chiller’s removable side panel. 4. T-507 Temperature Controller Operation Clean dust filters, check refrigerant levels, or reduce
The CWFL-6000 utilizes a digital T-507 (or similar upgrade) controller. It features two primary operational modes: Intelligent Mode (Default)
Чиллер S&A (TEYU) CWFL-6000 для охлаждения ... - К2 Тул
Use a dedicated circuit breaker matching the current specifications found on the chiller’s nameplate.
use tap water or well water. Mineral buildup will clog the laser's internal channels.
You need to load content from reCAPTCHA to submit the form. Please note that doing so will share data with third-party providers.
More Information