V2000-c Rfid Access Control User Manual //top\\ Jun 2026

This is your first task. Do not skip.

Press * followed immediately by your 6-digit Master Admin Code (The default out-of-the-box master code is 990101 or 123456 depending on production batch), then press # . The indicator status light will shift or flash, showing the terminal is ready for inputs.

Before installation, ensure your environment meets the following requirements: DC 12V ±10% User Capacity: 1,000 to 2,500 users (model dependent) Card Reading Distance: 3–6 cm Card Type: ID (EM) card or IC (Mifare) card Output Interface: Wiegand 26 (for external readers) Lock Output Load: Max 3A 2. Installation and Wiring

(Note: this is an instructional and practical guide meant to complement the official user manual. Always consult the manufacturer’s manual and local regulations before installation.) V2000-c Rfid Access Control User Manual

| Issue | Common Solution | | :--- | :--- | | | The card is not registered in the device, or the ID format is incorrect. | | Door won't open | Check power supply (ensure 12V is stable) or check relay wiring (NO vs NC settings). | | Forgot Admin PIN | Perform a hardware reset (usually involves shorting specific pins on the motherboard or pressing a reset button inside the casing). | | Cannot read cards | Clean the sensor area. If using ID cards, ensure the device supports 125kHz frequency. |

To perform any administrative task, you must first enter the system's programming mode.

If you forget the Master Code or wish to clear all settings: Power off the device. Press and hold the # key while powering the device back on. This is your first task

Before programming the device, it must be wired correctly to a dedicated access control power supply (which handles the high-current switching of electronic locks). Wire Color and Terminal Descriptions

By default, the relay stays open for 5 seconds. You can adjust this from 0 to 99 seconds to accommodate slower-moving individuals or specific automated door gates. Enter programming mode. Press 3 .

| Parameter | Specification | |:----------|:--------------| | Operating Voltage | DC 12V ±10% | | Unlock Current | ≤1000mA | | Standby Current | ≤60mA | | User Capacity | 1000 standard users | | Read Distance | 5~15cm | | Supported Card Type | EM 125kHz standard card | | Working Temperature | -10°C to 70°C | | Working Humidity | 10% to 90% | | Dimensions | 117 × 117 × 21 mm | | Unlock Relay Rating | 12VDC / 2A | | Alarm Output | 20A max | The indicator status light will shift or flash,

Egress input loop. Connect to a standard Exit Button.

The V2000-c uses a star-prefix command structure. [Master Code] + [#] .

This is your complete technical resource. Unlike a basic quick-start guide, this document dives deep into wiring schematics, advanced programming commands, error resolution, and maintenance protocols. By the end of this guide, you will master every function from adding a single card to configuring anti-passback logic.